Saturday, 28 December 2013

2007 Toyota Fj Cruiser Headrest Dvd Rse Installation

 2007 Toyota Fj Cruiser Headrest Dvd Rse Installation
download
2. Front Driver and Passenger Seat Removal CAUTION: Before beginning Step 2 wait for at least 90 seconds after disconnecting the cable to prevent the airbag from deploying. STOP NOTE: The procedures described below are for the both the front driver and passenger seats, unless otherwise specified. STOP (a) Remove Front Seat Track Covers 1. Using a Panel Removal Tool, carefully pry upward and remove the track covers. (Fig. 2-1) 2. Lift up on the area where the claw was removed. Then push in the direction of the claw on the opposite side to remove the outside claw. (Fig. 2-2) 3. Carefully pull the front seat track cover rearward and remove the front seat track cover. (Fig. 2-3) 37 N-m 27 Ft-lbf. Tape x4 Fig. 2-4 14 mm Socket Fig. 2-5 (b) Remove Front Seats STOP CAUTION: The procedure described below can affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before proceeding (See page RS-1 of the service manual). (1) Move the front seats to the most forward position. (2) Remove the two 14mm bolts from the rear side. (Fig. 2-4)
(3) Move the front seats to the most rearward position. (4) Remove the two 14mm bolts from the front side. (Fig. 2-4) (5) For reinstallation, torque to 27 ft-lbf (37 N-m) (6) Tilt the seat backward exposing the bottom side. (7) Disconnect the connectors under each seat (refer to service manual): For Driver Side: (Fig. 2-5) For Passenger Side: (Fig. 2-6) (8) Tape Seat Feet (4) with masking tape to prevent scratching vehicle during the removal and reinstallation. (Fig. 2-4) STOP STOP (9) Remove the front seats and store on protective blanket. CAUTION: Place protective blanket on door entry. Be careful not to damage the vehicle door trim when removing the seats.

No comments:

Post a Comment