2010 Toyota Prius Ec Rearview Mirror Installation
download
(d) Disengage driver side sun visor holder from the roof by turning the visor holder approximately 45˚ and pull it out as shown in the illustration. (Fig. 2-4) (e) Using panel removal tool, pry DRIVER SIDE visor mount cover off from visor mount. (Fig. 2-5) (f) Using panel removal tool, pry downward on visor mount to disengage two (2) clips and remove visor. (Fig. 2-6) (1) If metal clips get stuck in the clip hole, remove from hole and reinstall onto the visor. (g) Pull weather-stripping down past top of A- pillar garnish. (Fig. 2-7) (h) Detach A-pillar garnish from body. (1) Pull the upper part of the garnish toward the inside of the cabin and disengage the two (2) clips. (Fig. 2-8) (2) Note the orientation of the clip.
(d) Disengage driver side sun visor holder from the roof by turning the visor holder approximately 45˚ and pull it out as shown in the illustration. (Fig. 2-4) (e) Using panel removal tool, pry DRIVER SIDE visor mount cover off from visor mount. (Fig. 2-5) (f) Using panel removal tool, pry downward on visor mount to disengage two (2) clips and remove visor. (Fig. 2-6) (1) If metal clips get stuck in the clip hole, remove from hole and reinstall onto the visor. (g) Pull weather-stripping down past top of A- pillar garnish. (Fig. 2-7) (h) Detach A-pillar garnish from body. (1) Pull the upper part of the garnish toward the inside of the cabin and disengage the two (2) clips. (Fig. 2-8) (2) Note the orientation of the clip.
(3) Rotate the center portion of the clip 90˚, then pull the pillar garnish to release the tip of the clip from the pillar garnish. (Fig. 2-8) (1) If using needle-nose pliers
to twist the clip, put masking tape around the jaws to prevent clip
damage. (4) DO NOT remove the clip from the A- pillar body. If the clip
shows any signs of damage or is removed from the body, replace with a
new clip. (5) Disengage the three (3) guides and remove the front
pillar garnish. (Fig. 2-8) (i) Disengage the three (3) claws and front
pillar garnish corner piece as shown in illustration. (Fig. 2-9) (j)
Remove the driver side inner door scuff plate. (Fig. 2-10) (k) Remove
the driver side cowl cover. (Fig. 2-11)
Phillip’s Screwdriver Phillip’s Screw (l) Remove the Lower IP
panel. (1) Remove the Phillip’s screw from the lower IP as shown in illustration. (Fig. 2-12) Fig. 2-12 (2) Disengage the six (6) claws and clip as shown in the illustration.
(Fig. 2-13) (3) Disconnect any connectors connected to the lower IP.
Fig. 2-13 (4) Disengage the claw and 2 guides and disconnect the hood lock control cable. (Fig. 2-14) Fig. 2-14 10-Pin Connector 3. Install T-Taps. (a) Locate the disconnected 10 pin Outer Mirror Switch connector. (Fig. 3-1)
No comments:
Post a Comment