Repairing Manual 2009 Toyota Venza Roof Drip Molding Loose
2009 Toyota Venza vehicles may exhibit a condition where the Roof Drip Moldings become loose. An improved part has been developed to correct this condition Repair Procedure Standard Roof Disassembly 1. Remove the roof drip center side finish molding (without sliding roof). A. Put protective tape around the roof drip center side finish molding. B. Using a molding remover, disengage the 2 clips and remove the roof drip center side finish molding. NOTE • Do NOT remove the clips. • If the clips are damaged or separated, replace them with new clips. 2. Remove any dirt, debris, etc. from thechannel (all surfaces) and wipe with rubbing alcohol, taking care to prevent any contamination after wiping. Reassembly 1. Remove the release liner from the front piece of tape. 2. Set the molding into the front clip. 3. Install the front half of the molding in the channel by setting the outboard edge and lip first, then rotating the inboard edge and lip down into the channel, working from the front toward the rear. Stop just above the middle of the rear door opening.
No comments:
Post a Comment