2005 Hyundai Elantra Replacement Rear Brake Shoes
download
CAUTION: Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health. ^ Avoid breathing dust particles ^ Never use an air hose or brush to bean brake assemblies. 1. Disengage the upper return spring (A). 2. Remove the shoe hole down pins (B) by pushing the shoe hole down washer (C) and turning them. 3. 4. 5. 6. 7. Lower the brake shoe assembly (A), and remove the lower return spring (B). Make sure not to damage the dust cover on the wheel cylinder. Disconnect the parking brake cable from the parking brake lever. Remove the brake shoe assembly. Remove the upper return spring (C), self – adjuster lever (D) and self – adjuster spring (E), and separate the brake shoes. Connect the parking brake cable to the parking brake lever. 8. Clean the threaded portions of adjuster sleeve (A) and push rod female (B). Coat the threads of the adjuster assembly with grease (Castrol grease K764).
CAUTION: Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health. ^ Avoid breathing dust particles ^ Never use an air hose or brush to bean brake assemblies. 1. Disengage the upper return spring (A). 2. Remove the shoe hole down pins (B) by pushing the shoe hole down washer (C) and turning them. 3. 4. 5. 6. 7. Lower the brake shoe assembly (A), and remove the lower return spring (B). Make sure not to damage the dust cover on the wheel cylinder. Disconnect the parking brake cable from the parking brake lever. Remove the brake shoe assembly. Remove the upper return spring (C), self – adjuster lever (D) and self – adjuster spring (E), and separate the brake shoes. Connect the parking brake cable to the parking brake lever. 8. Clean the threaded portions of adjuster sleeve (A) and push rod female (B). Coat the threads of the adjuster assembly with grease (Castrol grease K764).
To shorten the clevises, turn the adjuster bolt (C). 9. Hook the
self-adjuster spring (D) to the adjuster lever first, then to the brake shoe. 10. Install the adjuster assembly and upper return spring (E), noting the installation direction. Be careful not to damage the wheel cylinder dust covers. 11. Install the lower return spring (F). 12. Apply brake cylinder grease or equivalent rubber grease to the sliding surfaces shown. Wipe off any excess, Don’t get grease on the brake linings. 13. Apply Nyogel 744MS to the brake shoe ends and opposite edges of the shoes shown. Wipe off any excess. Don’t get grease on the brake linings.
No comments:
Post a Comment