2001–2004 Nissan Pathfinder Driver’s Seat (With Adp Only) Won’t Move Forward Or Backward

2001–2004 Nissan Pathfinder Driver’s Seat (With Adp Only) Won’t Move Forward Or Backward

download
Applied vehicles: if you confirm: the driver’s seat will not move in the forward or backward direction, 2001 – 2004 pathfinder (r50) equipped with adp only actions: 1. Confirm this bulletin applies (see steps 1 and 2 of the service procedure). 2. If needed, install the seat slide motor kit (see parts information). Important: do not replace the entire seat adjuster assembly for this incident, if it should occur. This is the only approved repair procedure for this incident. A claim to nissan for the repair of this incident may be denied if the repair is not performed exactly as outlined in this bulletin. Service procedure 1. Using the power seat switch, tilt the front edge of the seat bottom all the way up. 2. Check voltage to the seat slide motor as follow:

• measure voltage between terminal 1 (“br” wire) and terminal 2 (“w/b” wire) in the seat slide motor connector (b518). • see figure 2. For more detailed information, refer to “automatic drive positioner” in the el section of the appropriate service manual (esm). Warning: when checking the power seat slide motor circuit, do not confuse its black connector (b518) with the side air bag module yellow connector. • this voltage check can be done with the seat slide motor connected. • if the voltage is about 12v when the seat slide switch is pressed to the “forward” and “backward” positions this bulletin applies, proceed to step 3. • if voltage is 0v when the seat slide switch is pressed to either the “forward” or “backward” positions, this bulletin does not apply. Use the el section of the appropriate service manual (esm) to further diagnosis and repair the incident. 3. Record the radio station pre-sets for later reprogramming after the procedure.