1998-2005 Nissan Frontier, Xterra Multi-Function Switch Removal & Installation
download
Fig. Multi-function switch component locations 1998-2000-2000 shown NOTE Before servicing, or working around, the SRS system, turn the ignition switch OFF, disconnect both battery cables and wait at least three minutes. When servicing, or working around, the SRS system do not work directly in front of the air bag module. 1. Before servicing the vehicle, refer to the Precautions Section. 2. Position the front wheels in the straight ahead position. 3. Disconnect the negative battery cable. Disconnect the positive battery cable. 4. Remove the side lids, located on the steering wheel. 5. Remove the right and left side special (Torx) bolts. 6. Lift up on the air bag module. 7. Disconnect the air bag harness connectors.
Fig. Multi-function switch component locations 1998-2000-2000 shown NOTE Before servicing, or working around, the SRS system, turn the ignition switch OFF, disconnect both battery cables and wait at least three minutes. When servicing, or working around, the SRS system do not work directly in front of the air bag module. 1. Before servicing the vehicle, refer to the Precautions Section. 2. Position the front wheels in the straight ahead position. 3. Disconnect the negative battery cable. Disconnect the positive battery cable. 4. Remove the side lids, located on the steering wheel. 5. Remove the right and left side special (Torx) bolts. 6. Lift up on the air bag module. 7. Disconnect the air bag harness connectors.
Remove the air bag module.
8. Be sure the steering wheel is positioned in the neutral position.
9. Disconnect the horn connector from the steering wheel (floating horn
bracket). 10. Release the spiral cable connectors
from the steering wheel by sliding off the connector brackets. 11.
Remove the steering wheel locknut. 12. Using a steering wheel puller,
remove the steering wheel. 13. Remove the upper and lower
steering column covers. Remove the knee protector, if equipped. 14.
Disconnect the spiral cable connector from the air bag harness. 15.
Loosen and remove the spiral cable retaining screws. Remove the spiral
cable. NOTE Do not disassemble the spiral cable. Do not apply lubricant
to the spiral cable. 16. Each switch can be replaced without removing
the multi-function switch base. 17. To remove the multi-function switch
base, remove the base retaining screws. Fig. Combination switch
removal points-1998-2000
To install: 1. Installation is the reverse of the removal procedure.
2. Be sure the front wheels are position the front wheels in the straight
ahead position. 3. Align the turn signal cancel tab with the notch of
the combination switch (see illustration). 4. Rotate the spiral cable
fully (clockwise) until tight. 5. Rotate the spiral cable
(counterclockwise) approximately 2.5 turns from the neutral position if
the vehicle is equipped with power steering
and approximately 4.0 turns from the neutral position if the vehicle is
not equipped with power steering. Align the white pin with the arrow on
the housing. NOTE When the spiral cable is centered, the white pin is
aligned with the arrow on the housing and the yellow wheel shows in the
window. CAUTION The spiral cable may snap during steering operation if
the spiral cable is installed in an improper position. Also, with the
steering linkage disconnected, the cable may snap by turning the
steering wheel beyond the specified number of turns. NOTE Always
perform the SRS self diagnostics check after installing the air bag
module.
No comments:
Post a Comment