1994 Chevrolet Corvette Door Panels Removal & Installation
download
1984-89 Vehicles See Figure 1 1. Raise the hood, then disconnect the negative battery cable. 2. Unfasten the 2 screws attaching the armrest to the trim panel. Push the armrest inward to remove the plastic hooks on the armrest from the slot on the door trim panel. 3. If equipped, remove the armrest filler. 4. Remove the retaining screws, then remove the speaker grille. 5. If equipped, remove the manual lock knob. 6. Unfasten the accessory trim plate screws. Note there is a hidden screw behind the door release handle. 7. Detach the electrical connectors from the hatch lid release switch, door lock courtesy light and, if removing the drivers side door panel, the wiper switch. Fig. Fig. 1: Exploded view of the door trim panel-1984-88 vehicles 8. Remove the accessory trim plate. 9. Remove the remote control plate and the courtesy lamp. 10. Remove the upper molding an air outlet.
1984-89 Vehicles See Figure 1 1. Raise the hood, then disconnect the negative battery cable. 2. Unfasten the 2 screws attaching the armrest to the trim panel. Push the armrest inward to remove the plastic hooks on the armrest from the slot on the door trim panel. 3. If equipped, remove the armrest filler. 4. Remove the retaining screws, then remove the speaker grille. 5. If equipped, remove the manual lock knob. 6. Unfasten the accessory trim plate screws. Note there is a hidden screw behind the door release handle. 7. Detach the electrical connectors from the hatch lid release switch, door lock courtesy light and, if removing the drivers side door panel, the wiper switch. Fig. Fig. 1: Exploded view of the door trim panel-1984-88 vehicles 8. Remove the accessory trim plate. 9. Remove the remote control plate and the courtesy lamp. 10. Remove the upper molding an air outlet.
11. Unfasten the door trim panel retaining screws, the pull the panel partially away from the door. 12. Detach the hatch lid release switch
electrical connector. 13. Remove the door panel from the vehicle. 14.
Installation is the reverse of the removal procedure. 1990-96 Vehicles
See Figures 2 and 3 1. Disconnect the negative battery cable. 2.
Remove the accessory/inside handle bezel, as follows: 3. Remove the
courtesy lamp from the bezel by gently prying down on the top edge,
about 1 / corners and rotating the lamp downward and out. a. Remove the
remote control lock knob from the rod by carefully prying it outward.
b. If removing the right door panel, remove the armrest filler panel by
unfastening the screws retaining the armrest filler. c. Remove the
bezel screws. The right and left side bezels may have different numbers
of screws. d. Pull the inside handle outward, then reposition the
bezel. e. Detach the courtesy lamp harness from the wiring harness connector. f. Unplug the electrical connector from the door lock switch. g. Remove the bezel.
No comments:
Post a Comment