Repairing Manual 2000–2007 Toyota Sequoia Back Door Power Window Inoperative

Repairing Manual 2000–2007 Toyota Sequoia Back Door Power Window Inoperative

download

Some 2001 – 2007 model year Sequoia vehicles may experience a condition where the back door power window of the vehicle is inoperative/stuck in the closed position. The following procedure has been developed to address this condition. TSB Overview This TSB applies to 2001 – 2007 model year Sequoia vehicles. All vehicles exhibiting the condition will receive a new back door power window motor. 2005 – 2007 model year vehicles will receive a new back door power window motor AND a back door ECU as per the Parts Information section. In addition, on ALL model year vehicles, the back door stopper must be removed (refer to step 14 in the Repair Procedure). Repair Procedure 1. Disconnect the negative (–) terminal of the vehicle battery. NOTE Any time the negative (–) battery terminal has been disconnected,systems requiring initialization will need to be re-initialized after the negative (–) battery terminal has been reconnected.

2. Open the back door and leave open. 3. Using the plastic pry tool, remove the back door garnish center. 4. Using the plastic pry tool, remove the left and right back door side garnish panels. 5. Remove the strap cover, bolt, and pull strap. NOTE To remove the strap cover, push it toward the back door window as shown in the illustration. 6. Remove the backdoor trim board. A. Insert the plastic pry tool between the back door trim board to release the clips retaining the backdoor trim. NOTICE Be careful NOT to damage the back door and back door trim board. B. Release each clip as shown in the illustration. 7. Disconnect both connectors to the back door ECU and both clips holding the wire harness to the large service cover.

8. Remove both back door service hole covers. • For 2001 – 2004 model year Sequoia vehicles — go to step 11. • For 2005 – 2007 model year Sequoia vehicles — continue to step 9. 9. For 2005 – 2007 model year Sequoia vehicles ONLY: Remove the multiplex network door ECU. Using a drill 3.2 mm (0.126 in.) or shorter, drill out the two (2) rivet heads. HINT Placing the drill vertically over the rivets may provide the best results during rivet removal. CAUTION Be careful when handling the rivets as they may be HOT. 10. For 2005 – 2007 model year Sequoia vehicles ONLY: Install the replacement multiplex network door ECU and rivets.