Haynes Auto Repair 1998 Honda Civic Fog Lights Installation Instructions
INSTALLATION 1. Write down the radio station presets; the radio memory will be erased when you disconnect the battery.Illustration of the Fog Lights Installed on the Vehicle Cutting the Front Bumper 2. Disconnect the negative cable from the battery. 3. While wearing gloves, remove the cutouts in the bumper with a utility knife. Cut the eight tabs in the area shown. 4. Using scissors, cut out the marked area from the template along the dotted line. 5. Position the template on the center grille rib, and mark the grille rib along the edge of the template with a felt-tip pen (two places). 6. While wearing gloves, cut out the center grille rib with a hacksaw blade: • Cut along the outer edge of the mark.
Do not cut through the mark. Take care not to damage the bumper with the hacksaw blade. • File the cut edge up to the mark, and remove any burrs. Routing the Fog Light Harness 8. At the front bumper grille, route the 1-pin connector and ground terminal of the fog light harness into the engine compartment through the front bulkhead below the driver’s side headlight. 2-PIN CONNECTOR CONDENSER (If equipped with A/C) 9. Route the remaining section of the fog light harness along the front bumper, and pull the 2-pin connectors out through the holes you just cut in the bumper.
for different information visit .http://www.iboelfiles.com/auto-repair-1998-2002-honda-accords-troubleshooting-at-dtcs-p0753-p0758-p1705-p1768/
No comments:
Post a Comment