Auto Repairing 2007 Toyota RAV4 Steering Column Assembly
download
REMOVAL CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing the steering column. 1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Waitat least 90 seconds after disconnecting the cablefrom the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. 3. REMOVE STEERING PAD (b) Using SST, remove the steering wheel. SST 09950-50013 (09951-05010, 09952-05010, 09953-05020, 09954- 05021) NOTICE: Apply a small amount of grease to the threads and tip of SST (center bolt) before use.
5. REMOVE STEERING COLUMN COVER NOTICE: Failure to follow the correct removal procedure may damage the claws. (a) Release the tilt lever. (b) Press the both sides of the lower steering column cover to disengage the 2 claws. HINT: The claws can be disengaged by pushing the lower steering column cover toward the front of the vehicle while pulling the upper steering column cover. (c) Insert your finger through the tilt lever opening in the lower steering column cover and disengage the claw.
(d) Disengage the 2 claws and remove the lower steering column cover. (e) Disengage the 3 claws, 4 clips, and 2 pins and separate the upper steering column cover. 6. REMOVE SPIRAL CABLE SUB-ASSEMBLY (a) Disconnect all connectors from theturn signal switch with spiral cable. 7. REMOVE COMBINATION SWITCH ASSEMBLY (a) Detach the clamp shown in the illustration and remove the combination switch from the steering column. 8. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY (a) Remove the instrument panel. 9. DISCONNECT POWER STEERING ECU (a) Detach the power steering motor wire harness and torque sensor wire harness clamps from the power steering ECU side. (b) Disconnect the 2 steering column connectors from the power steering ECU. 10. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL
No comments:
Post a Comment