Auto Repair 2009 Honda CR-V Windshield Washer Pump Does Not Work
SYMPTOM The windshield washer pump does not work. PROBABLE CAUSE Impact to the front bumper pushes the bumper back far enough to break the washer pump hose fitting. CORRECTIVE ACTION Replace the windshield washer reservoir and washer motor with updated parts. REPAIR PROCEDURE 1. Turn the ignition switch to ACC (I) to unlock the steering column. 2. Raise the vehicle on a lift. 3. Remove the right front inner fender. 5. Remove the clip from the filler neck, then remove the filler neck. FILLER NECK CLIP BOLT 6. Remove the right front fender trim, and disconnect the washer hose from the 90-degree fitting. 7. Disconnect the 2P connector and the two washer tubes from the washer motor.
8. Remove the washer reservoir clip and the three bolts, then pull out the reservoir. 9. Assemble the new reservoircomponents, but do not install the filler neck. 10. Trim 85 mm off the end of the 1,260 mm washer tube only. 11. Route the washer tubes on the reservoir. NOTE: The black fitting is for the front windshield nozzles, and the white fitting is for the rear nozzle. 85 mm
No comments:
Post a Comment