2008 Toyota 4Runner Roof Rack Cross Bar Installation

 2008 Toyota 4Runner Roof Rack Cross Bar Installation

download
To prevent paint damage during transportation, the roof rack cross bars are kept inside the vehicle so that the Rapgardt protective film can remain in place on the roof panel. Install the roof rack cross bars to the roof rack rails according to the following procedure during Pre-Delivery Service (PDS). Installation Procedure (Continued) 2. Slide the cross bar ends into the grooves of the right and left roof rack rails with the arrow on each cross bar facing forward. NOTE: The cross bars will create wind noise at highway speeds if they are installed backwards. 3. Align the ends of the front and rear cross bars with the paint marks on the roof rack as illustrated. Then securely tighten the knobs.

NOTE: Placing the cross bars at the paint marks on the roof rack side rails minimizes wind noise generated by the cross bars. 4. Install the right and left rear roof rack leg covers. A. Insert the protrusion at the front of the cover into the roof rack rail. B. Place the cover on the leg, aligning each rear end. At this time, do NOT press the cover down. C. Engage the cover claws located toward the outside of the vehicle. D. Engage the cover claws located toward the inside of the vehicle. NOTE: If the inside and outside cover claws are pressed down at the same time, the cover claws may be damaged. E. Check that the cover is installed securely.