2006 Mazda 3 s Engine Front Cover Installation
download
1. Apply silicone sealant to the engine front cover as shown in the figure. CAUTION: Install the engine front cover within 10 min of applying the silicone sealant. Silicone sealant is not need in area C as indicated below due to an existing. They are oil and a thing without adhesion of dust to a seal side. Thickness A: 2.2-3.2 mm {0.087-0.125 in} B: 1.5-2.5 mm {0.059-0.098 in} Fig. 38: Applying Silicone Sealant To Engine Front Cover 2. Install the engine front cover bolts in the order shown in the figure. 1. Apply clean engine oil to the oil seal. 2. Push the oil seal slightly in by hand. 3. Compress the oil seal using the SST and a hammer. NO. 3 ENGINE MOUNT RUBBER AND NO. 3 ENGINE MOUNT BRACKET INSTALLATION NOTE 1. Tighten the stud bolt of the No. 3 engine mount bracket. Tightening torque 7.0-13 N.m {71.4-132.5 kgf.cm, 62.0-115.0 in.lbf} NOTE: Tightening stud bolt when the nut of No. 3 engine mount nut is loosened. 2. Hand-tighten the No. 3 engine mount rubber and No. 3 engine mount bracket. 3. Tighten the bolts and nuts in the order as shown in the figure.
download
1. Apply silicone sealant to the engine front cover as shown in the figure. CAUTION: Install the engine front cover within 10 min of applying the silicone sealant. Silicone sealant is not need in area C as indicated below due to an existing. They are oil and a thing without adhesion of dust to a seal side. Thickness A: 2.2-3.2 mm {0.087-0.125 in} B: 1.5-2.5 mm {0.059-0.098 in} Fig. 38: Applying Silicone Sealant To Engine Front Cover 2. Install the engine front cover bolts in the order shown in the figure. 1. Apply clean engine oil to the oil seal. 2. Push the oil seal slightly in by hand. 3. Compress the oil seal using the SST and a hammer. NO. 3 ENGINE MOUNT RUBBER AND NO. 3 ENGINE MOUNT BRACKET INSTALLATION NOTE 1. Tighten the stud bolt of the No. 3 engine mount bracket. Tightening torque 7.0-13 N.m {71.4-132.5 kgf.cm, 62.0-115.0 in.lbf} NOTE: Tightening stud bolt when the nut of No. 3 engine mount nut is loosened. 2. Hand-tighten the No. 3 engine mount rubber and No. 3 engine mount bracket. 3. Tighten the bolts and nuts in the order as shown in the figure.
No comments:
Post a Comment