2010 Toyota Prius Remote Engine Starter Installation
download
1. Hood a. Place the vehicle in Park with the Parking Brake set. b. Remove the Rear Board. c. Remove the Rear Box. d. Remove the Rear Trims to gain access to the Battery. e. Disconnect the Negative Battery Terminal. • Note the Battery Cable Position as it will be re-installed in the same position. CAUTION: Do not touch Positive Terminal. f. Swap the Bolt and Nut on the Negative Battery Terminal from one side to the other for easier installation. WITH Hood Switch (Go to Next Section, Page 10) WITHOUT Hood Switch Fig. 1-5 Vehicles Without Hood Switch ONLY g. Dislodge the Radiator Hose to gain access to the Hood Latch Assembly. Fig. 1-7 EXAMPLE Make sure to hold the Hood Switch by its sides. Make sure the Hood Switch Lever is positioned properly. If the Hood Switch is Broken RES will not function.
1. Hood a. Place the vehicle in Park with the Parking Brake set. b. Remove the Rear Board. c. Remove the Rear Box. d. Remove the Rear Trims to gain access to the Battery. e. Disconnect the Negative Battery Terminal. • Note the Battery Cable Position as it will be re-installed in the same position. CAUTION: Do not touch Positive Terminal. f. Swap the Bolt and Nut on the Negative Battery Terminal from one side to the other for easier installation. WITH Hood Switch (Go to Next Section, Page 10) WITHOUT Hood Switch Fig. 1-5 Vehicles Without Hood Switch ONLY g. Dislodge the Radiator Hose to gain access to the Hood Latch Assembly. Fig. 1-7 EXAMPLE Make sure to hold the Hood Switch by its sides. Make sure the Hood Switch Lever is positioned properly. If the Hood Switch is Broken RES will not function.
Fig. 1-8 i. Install the Hood Switch with the Switch Lever
underneath the Hood Latch Trigger Lever. CAUTION: Make sure the Hood
Switch Lever is under the Latch Lever. j. Tighten 1 Screw. k. Connect
the Vehicle’s Hood Switch Connector to V4 Hood Switch Connector. Disconnect the Jumper Connector if installed. l. Reinstall the Hood Latch Assembly.
m. Torque the Hood Latch Bolts to 66.4 in•lbf (7.5 N•m). h. Dislodge
the Hood Latch Assembly. • Remove 3 Bolts. Make sure to hold the Hood
Switch by its sides. Make sure the Hood Switch Lever is positioned
properly. If the Hood Switch is Broken RES will not function. i.
Install the Hood Switch with the Switch Lever underneath the Hood Latch
Trigger Lever. CAUTION: Make sure the Hood Switch Lever is under the
Latch Lever. TVIP V4 REMOTE ENGINE STARTER (RES) n. Secure the Vehicle Hood Switch Harness to the Vehicle with 1 Wire Tie.
No comments:
Post a Comment