2010 Toyota Prius Rear Bumper Installation

 2010 Toyota Prius Rear Bumper Installation

download
1. Vehicle preparation. (a) Part and vehicle surface temperature must be maintained between 65˚F and 90˚F for optimum installation. Store parts flat at room temperature in a clean dry place. (b) Clean the entire application surface to remove grease and wax. Clean the entire area with a VDC approved cleaner and cleaning method. (c) Wipe the cleaned surface with a clean, dry, lint-free cloth. 2. Installation of the Rear Bumper Protector. (a) Place part face down on clean flat surface. Remove entire liner. (Fig. 2-1). (b) Spray bumper with soap and water solution. (Fig. 2-2). (c) Align the center notch directly below the striker latch opening and the leading edge of the premask along the ridge of the bumper being sure not to roll over the ridge.

Do not smooth part with hands. (Fig. (d) Spray premask with soap and water solution. (Fig. 2-4). (e) Using long smooth overlapping strokes squeegee from the center outwards of the horizontal section and begin to wrap over bumper. (Fig. 2-5). (1) Do not use excessive force as it may cause creasing of the protector. (f) Carefully remove premask paper 180˚ against itself prior to squeegeeing final wrap area. (Fig. 2-6). (g) Using sharp squeegee with protective sleeve, make smooth overlapping downward strokes from the center outwards of the final wrap area or the vertical section. (Fig. 2-7). (h) Dry off vehicle with clean lint free rag.