download
Exploded View Removal 1. Remove the intake manifold cover. 2. Disconnect the intake air temperature (IAT) sensor 2 connector (A), and remove the breather pipe (B), then remove the intake air duct (C). 3. Remove the positive crankcase ventilation (PCV) hose (A), brake booster vacuum hose (B), vacuum hose (C) and vacuum line mounting bolts (D). 4. Remove the evaporative emission (EVAP) canister hose (A) and the transmission breather hose clamp bracket (B). 5. Remove and plug the water bypass hoses (C). 6. Remove the engine wire harness connectors and wire harness clamps from the intake manifold. Intake air temperature (IAT) sensor 1 connector Throttle actuator connector Manifold absolute pressure (MAP) sensor connector Evaporative emission (EVAP) canister purge valve connector Intake manifold tuning (IMT) (intake manifold runner control (IMRC)) actuator connector
Exploded View Removal 1. Remove the intake manifold cover. 2. Disconnect the intake air temperature (IAT) sensor 2 connector (A), and remove the breather pipe (B), then remove the intake air duct (C). 3. Remove the positive crankcase ventilation (PCV) hose (A), brake booster vacuum hose (B), vacuum hose (C) and vacuum line mounting bolts (D). 4. Remove the evaporative emission (EVAP) canister hose (A) and the transmission breather hose clamp bracket (B). 5. Remove and plug the water bypass hoses (C). 6. Remove the engine wire harness connectors and wire harness clamps from the intake manifold. Intake air temperature (IAT) sensor 1 connector Throttle actuator connector Manifold absolute pressure (MAP) sensor connector Evaporative emission (EVAP) canister purge valve connector Intake manifold tuning (IMT) (intake manifold runner control (IMRC)) actuator connector
7. Remove the upper cover mounting bolts and nuts sequentially in
two or three steps, then remove the upper cover. Remove the intake manifold
mounting bolts and nuts sequentially in two or three steps, then remove
the intake manifold and spacer. Installation Install the gasket
and spacer on the injector base. Install the intake manifold. Tighten
the bolts and nuts sequentially in two or three steps. Always use a new intake manifold gasket.
3. Install the upper cover. Tighten the bolts and nuts sequentially
in two or three steps. Always use a new gasket. 4. Install the engine
wire harness connectors and wire harness clamps from the intake
manifold. Intake air temperature (IAT) sensor 1 connector Throttle
actuator connector Manifold absolute pressure (MAP) sensor connector
Evaporative emission (EVAP) canister purge valve connector Intake
manifold tuning (IMT) (intake manifold runner control (IMRC)) actuator
connector 5. Install the evaporative emission (EVAP) canister hose
(A), transmission breather hose clamp bracket (B), and water bypass
hoses (C).
No comments:
Post a Comment