2001 Mazda 626 ES Joint Shaft Removal/ Installation
download
1. Drain the transaxle oil. 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. Right Drive Shaft and Axle Removal Note 1. Remove the clinch bolt and nut. 2. Wrap a rag around the ball joint dust boot. 3. Pry the lower arm out of the knuckle. 4. Separate the right side drive shaft from the joint shaft by hammering on a bar inserted between them. Joint Shaft Removal Note – Install the SST into the transaxle to hold the side gears after the joint shaft is removed. Clip Installation Note – Install the new clip with the opening facing upward. Joint Shaft Installation Note 1. Install the joint shaft with the end-gap of a new clip facing upward. 2. Hand tighten the A bolts. 3. Tighten the A, B bolts to the specified torque. Tightening torque 43 – 61 Nm (4.3 – 6.3 kgf-m, 32 – 45 ft. lbs.) Right Drive Shaft and Axle Installation Note 1. Push the drive shaft into the joint shaft. 2. After installation, pull the front hub outward to verify that the drive shaft is securely held by the clip.
1. Drain the transaxle oil. 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. Right Drive Shaft and Axle Removal Note 1. Remove the clinch bolt and nut. 2. Wrap a rag around the ball joint dust boot. 3. Pry the lower arm out of the knuckle. 4. Separate the right side drive shaft from the joint shaft by hammering on a bar inserted between them. Joint Shaft Removal Note – Install the SST into the transaxle to hold the side gears after the joint shaft is removed. Clip Installation Note – Install the new clip with the opening facing upward. Joint Shaft Installation Note 1. Install the joint shaft with the end-gap of a new clip facing upward. 2. Hand tighten the A bolts. 3. Tighten the A, B bolts to the specified torque. Tightening torque 43 – 61 Nm (4.3 – 6.3 kgf-m, 32 – 45 ft. lbs.) Right Drive Shaft and Axle Installation Note 1. Push the drive shaft into the joint shaft. 2. After installation, pull the front hub outward to verify that the drive shaft is securely held by the clip.
No comments:
Post a Comment