1998 Subaru Legacy Outback How to remove and Install Oil Pan

1998 Subaru Legacy Outback How to remove and Install Oil Pan

download
REMOVAL 1) Remove front wheels. 2) Remove air intake duct. 3) Disconnect connector from front oxygen sensor. 3) Disconnect connector from front oxygen sensor.4) Disconnect connector from rear oxygen sensor, (California 2200 cc model only) 5) Remove pitching stopper. 6) Remove radiator upper brackets, 7) Support engine with a lifting device and wire ropes. 8) Lift-up the vehicle. CAUTION: At this time, raise up wire ropes. 9) Drain engine oil. Set container under the vehicle, and remove drain plug from oil pan. 10) Disconnect connector from rear oxygen sensor. (Except California 2200 cc model) 11) Remove front exhaust pipe. a) b) c) Separate front catalytic converter from center exhaust pipe. Remove front exhaust pipe from engine.

Remove bolt which installs front exhaust pipe on bracket. 12) Remove nuts which install front cushion rubber onto front crossmember. 13) Remove bolts which install oil pan on cylinder block while raising up engine. 14) Insert oil pan cutter blade between cylinder block-tool pan clearance. CAUTION: Do not use a screwdriver or similar tool in place of oil pan cutter. 15) Separate oil strainer from oil strainer stay. 16) Remove oil strainer. 17) Remove baffle plate and oil strainer stay. INSTALLATION CAUTION: Before installing oil pan, clean sealant from oil and engine block. 1) Install baffle plate and oil strainer stay. Tightening torque: 5 Nm (0.5 kg-m, 3.6 ft. lbs.) 2) Install oil strainer onto baffle plate. CAUTION: Replace O-ring with a new one. Tightening torque: 9.8 Nm (1.0 kg-m, 7 ft. lbs.)